How to design to make this height more reasonable? Let me show you. When we dropped the slider, three fatal mistakes in the Extrusion blowing machine industry almost broke our business.
● Judge the quality of the machine, judge the quality of the machine and equipment, and confirm the defects of the machine. For example, select Offline, Cannon, Hotline, and view the operation instructions.
● The standard of the button shall start to operate according to the established principle until the delivery point of the machine operation board, such as safe, stable and no-load operation when moving (board).
● Emergency stop button: the brake button shall be clearly disassembled according to the operation instructions. When the operator reaches the set command end point, the action shall be stopped.
● During the start of work, the whole machine should be completed at a relatively low speed. So far. First, determine the master control of the set, and then start production.
● When the machine is running, the input 5V3 acts to make 2M1 gradually reach the predetermined speed, which will be automatically sent to the base plate according to the requirements of the actual operating conditions.
● When the machine is running, the force causes the material barrel to separate from the film and press the upper and lower layers of mold, thus forming single and double sides. At the same time, the driving system of the elevator should maintain the speed of the rectifying force. Otherwise, turn the safety adjuster to the limit height position.
● The force when the machine is running, so that the control drive motor speed can be tested at a certain speed. The test data shows that the test run should be carried out before the weekly operation to ensure that the discharging is normal and stable until the inspection, and all actions of USB, A and B feeding are ensured by force.
● Apply anti-rust agent on the parts that are not in contact with the machine during operation, providing the machine with conditions that are resistant to corrosion and harsh environment. Unless it is really necessary, the antirust agent will generally be wiped off during operation, but it is forbidden to use solvent to wipe off the antirust agent.
● Before the start of each shift of the machine, grease can be added to the lubricating oil bucket in the bucket of moving parts. In addition to oil lubrication, the barrel, screw, etc. also need oil stain shaping.
Note: The machine (manual) device outputs butter from the upper part to make the baking pan overflow and fill up in time. If the capacity is sesame, or about, it is appropriate to feed when the voltage is lower than 300V.
● Operating voltage of molten oil load: 75 ± 10VA/LD, PU: 20 ± 002mm, high frequency error of EVOH section.
● Operating voltage of molten oil load: 75VA, KW: 20 ± 10VA/LD, applicable: 25/ Φ 300, applicable: 10~850bar.
The company integrates R&D and manufacturing, adopts advanced technology in the industry, introduces high-tech talents, establishes a modern enterprise system, and constantly improves management. The R&D department constantly develops new products, and strengthens technical content. At the same time, the company strengthens internal management, pays attention to integrity externally, and wins unanimous praise from customers at home and abroad with high-quality product quality.
Extruder, mixer, opening mill, film blowing machine, casting machine, plate vulcanizer, plastic granulator.
Main business: extruder, plastic granulator, internal mixer, open mixer, film blowing machine, flat vulcanizer, laboratory open mixer, small internal mixer, casting machine equipment, plastic extruder, small open mixer, rubber internal mixer, casting machine, small rubber flat vulcanizer.