The distributor of plastic bottle blowing machines with the best reputation for producing plastic bottles, as well as Chinese plastic bottle blowing machine athletes, should understand that correct operation of bottle blowing machines can effectively improve the strength of their products and generate a large amount of labor within the enterprise.
Before the start of each shift of the bottle blowing machine, the athletes should check whether the moving parts are secure, and together, check whether the reducer of the main machine is worn. If an unexpected malfunction occurs, it should be promptly resolved.
Is the air source switch of the bottle blowing machine flexible, whether the screws are loose or dropped, especially in areas with strong impact force, and whether the belt transmission part is abnormal.
Check if the installation of the bearings at both ends of the host bearing compartment is abnormal, and if the lubricating oil at the bearing area is leaking.
It is strictly prohibited to rotate without material, and it is not allowed to install oil bottles or drink oil in the position where the material barrel is not below, to avoid leakage.
When the air source switch is damaged or personnel alarms or emergency braking occurs, the mold cannot be closed to prevent air source fluctuations.
When opening the high and low pressure air source switch, it is necessary to act slowly to prevent dirt from blowing into the solenoid valve due to the fast flow rate of the air source. At the same time, open the exhaust valve for 30 seconds to ensure that the air is clean.
When starting the machine, it must be ensured that the mechanical parts are in good condition, there are no people inside the machine, and there are no foreign objects. Especially the position of the crank to avoid injury. Simultaneously close the safety door.
When starting the machine, the motor must be started first, and the heating machine must be started with a delay of 30 seconds to prevent voltage fluctuations. Before starting the heating, make sure that the cooling water is turned on. Fortunately, microprocessors can be equipped with heavy hammer and pressure protection devices
It is strictly prohibited to rotate the machine without material, and the main machine cannot be started when the material barrel, tee, and mold head do not reach the required temperature.
After starting the heating, the operator must not stand in front of the machine to avoid injury. If the machine does not reach the set heating temperature, a burn accident may occur.
The unstable current of the main machine of the film blowing machine is usually caused by the frequency converter, and temperature control instruments need to be installed to ensure the fluctuation of the power piston of the motor. If the current fluctuation of the motor is relatively large, it will affect the normal operation of the machine and need to be opened in a timely manner.
It is recommended to cut the knife to avoid affecting the normal operation of the machine and avoid accidents caused by accidents.
Whenever the machine is running, it is necessary to confirm whether the cutting tool is sharp to avoid cutting due to the length of the parts.
Before the machine runs, it is necessary to pre tighten the plastic film and ensure quality to avoid problems. For larger materials, try to ensure the thickness tolerance requirements during initial testing.
Before running the machine, it is necessary to check whether the parts of each part are secure and whether the screws are loose. Especially when the machine needs to be stopped, it must be closed properly.