Take you to know the dealer of KRONES Extrusion blowing machine

Plastic film blowing equipment, Jiangsu garbage bag film blowing machine price. Take you to know the dealer of KRONES Extrusion blowing machine.

The energy saving of film blowing machine can be divided into two parts: one is power heating; The second is the heated v-shape. The vest bag making machine is composed of two lines, including A, B and C. (1) The fixed temperature range can be from 10 ° C to 1500 ° C. U-type consists of fixed roller device, vibration device, electric control device and motor. This series of models is mainly applicable to the pressing device of plastic sheet (film, sponge), EPE foam cloth, white card, EPE, PVC foam cloth, TPU foam kraft paper, three-dimensional plate and other substrates.

● LSR materials are suitable for use in high temperature or low temperature environments. At high to 200 ° C or low to – 40 ° C, the insulation properties, mechanical properties and physical properties of the materials remain unchanged.

● The ejector pin can be used with different sliding plates, and the stroke can be adjusted freely. The demoulding force, the advance and retreat speed of the ejector pin and the demoulding times can also be preset as required.

● Check that the most popular accessories (sets) are not stuck at the hook edge. It is necessary to remind whether the falling plate of this section is consistent with the slot bar to prevent certain interference.

Please check that your blanking plug is too high. If this is an emergency, please contact immediately, and listen to the heat sensitivity caused by local overheating of the bag rod to prevent system damage.

PET Bottle Making Machine

Please also check your exhaust time setting. If the exhaust setting is normal and the failure occurs only once the bottle is blown each time, it can be judged that it is the problem of the exhaust valve. Please open the exhaust valve and check the condition of its spring and seal (another phenomenon of this failure is that the exhaust sound is loud or there is a noise that cannot be discharged).

We can investigate your exhaust time setting. If you need to adjust it as slowly as possible, it is undoubtedly the earliest version of conditioning. In addition, you can install two starters or servo motor drives on the board near the plug. This combination is usually made up of those with better flexibility to reflect the final plastic flow. Therefore, this factor is helpful for you. If you can stand in the perspective of being heated and affected, try not to change the performance of the track motion line.

The other end of the adjustable clamp may already affect the sag of the parison. If the sag of the adjusting material causes the sag of the parison during extrusion, the air around the clamp will also affect the sag of the parison surface. Therefore, the appearance of the general container is to be rented and customized. If it is not recommended to replace it.

Control the manual operation and change the circuit board of the machine. Not all remote operations will be completed until the auxiliary machinery reaches your company. The new control solution is to maximize the stability of servo machine equipment.

Bottle blowing machine factory, plastic bottle blowing machine manufacturer, how much is the oil bottle blowing machine, the price of high-speed bottle blowing machine, PET bottle blowing machine, and the price of large bottle blowing machine.

Scroll to Top