Secondly, when purchasing a second-hand automatic bottle blowing machine, you should carefully check the delivery time of the machine. The Ministry of Commerce expects that the foreign trade of Blowing machines will remain in a reasonable range throughout the year.
In the manufacturing process; At that time, we usually complete the blow molding mold within the specified production time. However, on the premise of declaring any requirements, we should also give due consideration and hope that you can find better ways to make them.
● Injection molding motorized formwork. In this case, the mold was originally rotated by hand, and then the mold was rotated by hand to rotate the printing box. The printing can be milled. The lubricating oil at both ends of the printing, printing mark and air blowing shall be finely polished. Manual scrubbing is sufficient.
● Measure the symmetry of various plastics and the defects of the surrounding environment with laser knife, oblique beam and scratch;
● Length. This kind of arc welding needs to have a tendency to wear. The pattern can only be tightened at a specific time for a specific material, otherwise it will cause oblique shooting.
● Length. After demoulding, the polymer required to work can be stripped to avoid defects or problems.
● Length. Generally, the length is only 5-10 mm, not more than 60 mm, not more than 2 mm.
● The inclined guide post is not designed properly and is not too tight. The inclined guide post only supports the base and is not suitable for use on traditional machine tools.
● The design of inclined guide post is not suitable for straightness change. This kind of arc welding should bear too much torque, and the design of inclined guide post is not suitable.
● The design of the inclined guide pillar is not suitable. The inclined guide pillar is not tightened. When the inclination is large, the inclined guide pillar will roll diagonally.
Either reduce the left foot, or increase the fitting area to adapt to the situation, or contact the small end of inclination.
Furthermore, the contact inclined guide pillar is mainly suitable for the 18-50 cm blind hole of the inclined guide pillar. When the budget is low, due to the inclined guide pillar, the inclined guide pillar will tend to have a blind hole of 18-50cm.
The company integrates R&D and manufacturing, adopts advanced technology in the industry, introduces high-tech talents, establishes a modern enterprise system, and constantly improves management. The R&D department constantly develops new products, and strengthens technical content. At the same time, the company strengthens internal management, pays attention to integrity externally, and wins unanimous praise from customers at home and abroad with high-quality product quality.
Extruder, mixer, opening mill, film blowing machine, casting machine, plate vulcanizer, plastic granulator.
Main business: extruder, plastic granulator, internal mixer, open mixer, film blowing machine, flat vulcanizer, laboratory open mixer, small internal mixer, casting machine equipment, plastic extruder, small open mixer, rubber internal mixer, casting machine, small rubber flat vulcanizer.