Market scale and prospect analysis of the bottle blowing machine products for producing mineral water bottles. Firstly, to meet the production needs of users, we must pay attention to the early debugging during design, manufacturing, and processing, in order to ensure the perfection of manufacturing. 2、 To ensure that the bottle blowing machine equipment is at a high level for a long time, especially in the early stages of pre blowing machine equipment, it is necessary to ensure that the equipped equipment can be carried out smoothly and have a high factory allocation rate. 3、 To ensure the smooth operation of the equipped mold equipment and certain engineering machinery, we can innovate in the process to determine the required forming conditions. 5、 To ensure the smooth operation of the matched molds and the full price adjustment of certain engineering machinery. 5、 To ensure the smooth operation of the matched mold, the machine used can smoothly complete the section and ensure stable production capacity; Secondly, the bottom of the leftover material can withstand significant pressure, so it is necessary to avoid damage to the inclined surface of the bottom in the direction of the material pipe. 5、 To ensure uniform wall thickness and lubrication through ramps and edge materials, it is necessary to ensure smooth coverage for a long time. 6、 To ensure uniform wall thickness and pass through the weft line of the ramp, it is necessary to ensure uniform wall thickness. 7、 Flat pressing in the direction of the mold is not parallel, otherwise it will produce a slope; 7、 To ensure uniform wall thickness and the purpose of passing through ramps and returning materials, otherwise a slope will be formed. 7、 When locking the mold, it should not be too high, otherwise it will be severely damaged. 7、 Ensure that each nail is evenly tightened during mold locking, otherwise it will affect normal production. When extracting the oil cylinder, the start and stop buttons should be followed to prevent voltage fluctuations. Due to the fact that the locking action is a spring reset, it should not affect the electrical performance during mold closing and should be adjusted appropriately. The bottle head is somewhat swollen (3-5), and under the action of the bottom wheel, the bottle preform should maintain the same injection position to prevent the bottle preform from entering the Chlie wall river at the same time, causing serious pollution to the bottle preform mold locking. At the sealing ring, there is friction suppression on the sealing ring, allowing the bottle embryo to be inserted into the sealing ring to seal the bottle body. If it is necessary to add another power source when cutting off the power supply in order to ensure the efficient flow of the bottle embryo.
The thickness of the sealing ring at the bottom of the bottle is 1mm, and the protective cover # sealing ring on the inner wall of the bottle mouth is determined at the factory. 2mm, bottle body pressure resistant. 3mm, the bottom of the bottle needs to have chrome plating attached, and the convex container and bottle preform surface should be flat and free from wrinkles.
The bottom of the cap is sealed with a sealing ring at the bottom of the bottle, and the seal is a protective device. When replacing the sealing cylinder or mold, protect the bottom of the bottle from valve or core jamming.
By controlling a cylinder, the speed of the sealing cylinder is ensured. At the same time, the actions of the sealing cylinder and the sealing cylinder approach with the cycle, but the operating speed of the main compressor in the mechanical department will also be affected.
